Basic Helpful Tips

• Prior to installing InfintiStone, it is important to decide whether waterproofing is required on your substrate. All wall boarding joins and screw holes must be sealed properly. If in doubt, consult your nearest board manufacturer.
• Ensure to leave a joint between abutting surfaces eg start 10mm off floor.
• Start your Corners first, alternating the long and short returns as you work upwards.
• Be sure to keep the work level as you go. Snap a chalk line or a level to check every few rows.
• Use a trowel edge, nipper or other sharp, blunt tool to trim stones. For straight cuts, use a grinder with a diamond or masonry blade.
• Conceal trimmed edges with grouting where applicable, or hide them by turning the cut side upward above eye level or downward below eye level.
• Avoid long sections of straight, unbroken grout lines in standard grout installations. Be sure to use a consistent joint width. A 10mm width is standard.
• When installing in a dry, hot climate or onto extremely dry surfaces, be sure to wet the stone and the wall first so they do not absorb moisture from adhesive. You can spray or otherwise apply water onto the back of the stone or dip it into water. Spray or brush water onto the wall as well. Allow both to dry a few minutes to remove excess water.
• For Adhesives, if using Laticrete 335 pre-mix Adhesive (or Equivalent), ensure to wipe off excess from face of stone immediately with a Wet Sponge otherwise it may be difficult to clean off when dry.
• For Grouting, if Laticrete Slate & Quarry Grout (or Equivalent) is used and accidentally falls on the face of a stone during installation, do not wipe it off. It will smear and discolour the stone. Instead, let it set until 'touch dry' - generally around 40-60 minutes dependent on weather, then brush it away with a dry whiskbroom.
• Avoid water runoff onto your installation. Divert water away with flashing.
• Do not install below water level, and do not expose stone to chemicals as it will stain the stone.
• Do not use wire brushes or acid on the stone surface.
• Local building codes vary. Be sure to check the requirements in your area.
• Lay out the stone near your work area first. As you install, choose stone that vary in colour tones, shape and size.
• Apply a 15-20mm layer of adhesive to the entire back of the stone.
• Press the stone into place with a gentle back-and-forth motion until the adhesive squeezes out around the edges.

Standard Grout Installation Tips:

• Apply all stone to wall, let it set, then use a grout bag to fill in the joints with grout.
• Grout/mortar joints take 30 to 60 minutes to 'Touch Dry' - this depends on weather. When they do, use a striking tool to scrape or rake out the excess grout at a consistent depth while smearing it along the joint seams for a good seal.
• Smooth the joints and brush any loose grout/mortar with a whiskbroom.

Drystack Installation Tips:

• Drystack stone may need to be moistened before installation, as described in the Basic Installation Hints above.
• Lay out the stone near your work area. As you install, choose stones that vary in colour, shape and size.
• Apply stone from the bottom up.
• Apply a 15-20mm layer of adhesive to the entire back of the stone.
• Press the stone into place with a gentle back-and-forth motion until the adhesive squeezes out around the edges.
• Remove any excess adhesive around the edges and pack it into gaps along the stone's edges.
• Once you finish applying all stone, touch up as necessary to hide cuts or fill voids as desired.

Important Note:

Please refer to our Website Terms & Conditions prior to using any materials & publications from this page. Usage will deem you have accepted our Terms & Conditions.